Thread: How to Portfoward A Bt-Home-Hub V.2[PICS]

Ok, first things first, I no there's already a guide posted on portfowarding but people who use the: Bt-Home-Hub V.2, router may have trouble portfowarding it as I did.

Difficulty: Medium (Though, this tutorial would make it easy)
Length: Medium (Depends on how good you are, can be short)

Bt-Home-Hub V.2

Step 1, Go to start>run.
Now a little box should appear just type in it: cmd and press enter.
There should be a black box appear type ipconfig and press enter you should see somthing like this:

[Only registered and activated users can see links. ]

Step 2, Copy the default gateway into your internet browser so in my case it would look like:

[Only registered and activated users can see links. ]

Press Enter.

Step 3, If it asks you for your username and password type it in (It doesn't with mine, yours might be the same.) If you don't no it and your parents have changed it ask them. (If they don't tell you exit this tutorial now!)

Code:

Default username/passwords are usually:
Username: admin
Password: password

Username: password
Password: admin

Step 4, Your router page should look similar to this: (I cut a bit of mine off at the bottom to fit the image)

[Only registered and activated users can see links. ]

Click settings it may ask your for a password, well type in your password, go back to step 3 if you need more information and it wont ask you for your password (Don't worry if it doesn't ask you for the password its not important.)

Step 5, Click advanced settings, and then Continue to advanced settings. Next, click: Application Sharing (As shown below.)

[Only registered and activated users can see links. ]

Next, click: Supported Applications (As shown below.)

[Only registered and activated users can see links. ]

Step 6, Click Add new game or application (Not going to screenie as its not hard to miss.)

Next, Fill in the information as shown below.

[Only registered and activated users can see links. ]

Purpose:

Code:

-Game/Application Name: Somthing that reminds you of why your adding the application.

Once filled in the information, if you have not done already click add so it will look like this:

[Only registered and activated users can see links. ]

Next, type in all of the boxers 43594 (Except the last one) and in the drop down box change 'TCP' to 'UDP' both times and click add. It should look like this:

[Only registered and activated users can see links. ]

Next, click apply as shown in the image above.
Then Click Configuration on the tab bar.
Under game and application you should see a drop down tab saying: Select game or application. Click it and look for your application name, once found click it(The drop down box has a red square around it to show where it is on your screen.)

[Only registered and activated users can see links. ]

Last of all, click the drop down tab under device, next to the Select game or application drop down tab, you should no where it is as it is marked in the above picture with a black box around it. (It says Select Device.) Once clicked, find: User Defined and click it and you will see a box where you have to type your device ip adress in. As before go to start>run and a box will appear, type cmd then a black box will appear and type ipconfig, look for your ip adress and type it into the box on your router page asking for the device ip adress and click add to the right of it.


Tadah, not so hard was it?

Post here if you are stuck or, visit [Only registered and activated users can see links. ] for some more imformation (However, this guide provides a lot more imformation.)

Thanks.